Gülöz Makina
WhatsApp

What Is a Taper Lock Bush and How to Install It

A taper lock bush is a tapered-bore fastening element used to mount pulleys, sprockets and couplings onto a shaft quickly and securely, without damaging the shaft. The hub of the component has a matching tapered bore; when the set screws are tightened, the tapered surfaces lock together and the component is held on the shaft with an interference-fit grip.

Advantages of taper lock bushes

  • Easy installation: the bush slides onto a keyed shaft by hand, with no hammer or press.
  • Shaft and key protected: the clamping force is spread over the taper, so the shaft does not wear and the key is not sheared.
  • Easy removal: screws moved to the removal hole push the bush out of the hub.
  • Lower stock: one pulley fits different shafts by changing only the bush bore.

How to read taper bush sizes

Taper bushes are identified by a four-digit number such as 1008, 1108, 1210, 1610, 1615, 2012, 2517, 3020, 3030, 3525, 3535, 4040, 4545 or 5050. The first two digits give the outside diameter and the last two digits the length, both in tenths of an inch. A 1610 bush is therefore approx. 1.6" in diameter and 1.0" long. Each size is available with a range of metric or inch keyed bores. The bush number must match the taper bore of the pulley hub. See our Taper Bushes page and catalogue for bore ranges, screw sizes and tightening torques.

Step-by-step installation

  1. Clean the bush, the hub bore and the shaft. Do not lubricate the tapered surfaces.
  2. Insert the bush into the hub and align the half holes (plain ↔ threaded).
  3. Fit the set screws loosely into the tightening holes.
  4. Slide the assembly onto the keyed shaft to the required position.
  5. Tighten the screws alternately and gradually to the torque given in the catalogue.
  6. Tap the large face of the bush lightly using a drift or sleeve, re-tighten to torque, and fill empty holes with grease.
  7. Re-check screw torque after a short run-in period.

How to remove a taper lock bush

  1. Remove all set screws.
  2. Insert one screw (two on larger sizes) into the removal hole.
  3. Tighten it until the bush is released from the hub.
  4. Slide the loose assembly off the shaft by hand.

Common mistakes

  • Oiling or greasing the tapered surfaces (can crack the hub).
  • Fully tightening one screw at a time, causing run-out.
  • Exceeding the tightening torque or hammering the bush directly.
  • Ordering a bush size that does not match the hub.

Gülöz Makina manufactures taper bushes, taper lock hubs, bush adapters and V-belt pulleys for taper bushes in Konya, Turkey, and exports worldwide. Contact us for the right bush size and bore for your application.

Other News
View the All

15
May

TIMING PULLEY DIMENSIONS AND HOW TO CHOOSE A TIMING PULLEY

Timing pulley profiles, pitch diameter and ordering information.

Read More >>>

06
February

WHAT IS A TAPER LOCK BUSH AND HOW TO INSTALL IT

Taper lock bush sizes, step-by-step installation and removal.

Read More >>>

05
February

11
October

HOW TO SELECT THE RIGHT COUPLING

Torque calculation, service factor and coupling types compared.

Read More >>>